Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To pass traffic through a configured prefix list, use the prefix list in a route redistribution command.

• Enter RIP mode. CONFIGURATION mode router rip
• Apply a configured prefix list to incoming routes. You can specify an interface. If you enter the name of a nonexistent prefix list, all routes are forwarded. CONFIG-ROUTER-RIP mode distribute-list prefix-list-name in [ interface]
• Apply a configured prefix list to outgoing routes. You can specify an interface or type of route. If you enter the name of a non-existent prefix list, all routes are forwarded. CONFIG-ROUTER-RIP mode distribute-list prefix-list-name out [ interface | connected | static | ospf]

Dell(conf-router_rip)#show config
                                 !
                                 router rip
                                 distribute-list prefix juba out
                                 network 10.0.0.0
                                 Dell(conf-router_rip)#router ospf 34