Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Configuring Filters Without a Sequence Number

If you are creating an extended ACL with only one or two filters, you can let the system assign a sequence number based on the order in which the filters are configured. The system assigns filters in multiples of five.

To configure a filter for an extended IP ACL without a specified sequence number, use any or all of the following commands:
  • Configure a deny or permit filter to examine IP packets. CONFIG-EXT-NACL mode {deny | permit} { source mask | any | host ip-address} [count [byte]] [order] [fragments]
  • Configure a deny or permit filter to examine TCP packets. CONFIG-EXT-NACL mode {deny | permit} tcp { source mask] | any | host ip-address}} [count [byte]] [order] [fragments]
  • Configure a deny or permit filter to examine UDP packets. CONFIG-EXT-NACL mode {deny | permit} udp { source mask | any | host ip-address}} [count [byte]] [order] [fragments]

The following example shows an extended IP ACL in which the sequence numbers were assigned by the software. The filters were assigned sequence numbers based on the order in which they were configured (for example, the first filter was given the lowest sequence number). The show config command in IP ACCESS LIST mode displays the two filters with the sequence numbers 5 and 10.

Example of Viewing Filter Sequence for a Specified Extended ACL 

Dell(config-ext-nacl)#deny tcp host 123.55.34.0 any
                                 Dell(config-ext-nacl)#permit udp 154.44.123.34 0.0.255.255 host 34.6.0.0
                                 Dell(config-ext-nacl)#show config
                                 !
                                 ip access-list extended nimule
                                 seq 5 deny tcp host 123.55.34.0 any
                                 seq 10 permit udp 154.44.0.0 0.0.255.255 host 34.6.0.0
                                 Dell(config-ext-nacl)#
To view all configured IP ACLs and the number of packets processed through the ACL, use the show ip accounting access-list command in EXEC Privilege mode, as shown in the first example in Configuring a Standard IP ACL Filter .

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \