Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

Example of Configuring MSDP

    R3_E600(conf)#ip multicast-msdp
                                 R3_E600(conf)#ip msdp peer 192.168.0.1 connect-source Loopback 0
                                 R3_E600(conf)#do show ip msdp summary
                                 
                                 Peer Addr   Local Addr   State     Source   SA   Up/Down Description
                                 192.168.0.1 192.168.0.3 Established Lo 0    1   00:05:29
                              

To view details about a peer, use the show ip msdp peer command in EXEC privilege mode.

Multicast sources in remote domains are stored on the RP in the source-active cache (SA cache). The system does not create entries in the multicast routing table until there is a local receiver for the corresponding multicast group.

R3_E600#show ip msdp peer
                                 
                                 Peer Addr: 192.168.0.1
                                 Local Addr: 192.168.0.3(639) Connect Source: Lo 0
                                 State: Established Up/Down Time: 00:15:20
                                 Timers: KeepAlive 30 sec, Hold time 75 sec
                                 SourceActive packet count (in/out): 8/0
                                 SAs learned from this peer: 1
                                 SA Filtering:
                                 Input (S,G) filter: none
                                 Output (S,G) filter: none