Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

The following figure shows the sample VLT topology.

Figure 1. Sample VLT Topology

In PMUX VLT, you can choose any uplink ports for configuring VLT.

• NOTE: Ensure the connectivity to ToR from each Aggregator.

1. Enable VLT in node 1 and 2.stack-unit unit iom-mode vlt CONFIGURATION mode Dell(conf)#stack-unit 0 iom-mode vlt
2. Verify the VLT configurations.show interface port-channel brief EXEC mode

   Dell# show interfaces port brief
                                       Codes: L - LACP Port-channel
                                       O - OpenFlow Controller Port-channel
                                       
                                       LAG      Mode  Status       Uptime      Ports          
                                       127  L2    up           00:18:22    Fo 0/33    (Up)<<<<<<<<ICL LAG
                                       Fo 0/37    (Up)
                                       L   128  L2    up           00:00:00    Fo 0/41    (Up)<<<<<<<<Uplink LAG