Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Restoring the Factory Default Settings

Restoring factory defaults deletes the existing NVRAM settings, startup configuration and all configured settings such as stacking or fanout.

To restore the factory default settings, use the restore factory-defaults stack-unit {0-5 | all} {clear-all | nvram} command in EXEC Privilege mode.

  • CAUTION: There is no undo for this command.

Important Points to Remember

  • When you restore all the units in a stack, all units in the stack are placed into stand-alone mode.
  • When you restore a single unit in a stack, only that unit is placed in stand-alone mode. No other units in the stack are affected.
  • When you restore the units in stand-alone mode, the units remain in stand-alone mode after the restoration.
  • After the restore is complete, the units power cycle immediately.

The following example shows the using the restore factory-defaults command to restore the Factory Default Settings.

Restoring the Factory Default Settings 

Dell#restore factory-defaults stack-unit 0 nvram
                                 ***********************************************************************
                                 * Warning - Restoring factory defaults will delete the existing      *
                                 * persistent settings (stacking, fanout, etc.)                       *
                                 *  After restoration the unit(s) will be powercycled immediately.     *
                                 * Proceed with caution !                                             *
                                 *********************************************************************** Proceed with factory 
                                 settings? Confirm [yes/no]:yes
                                 -- Restore status -- Unit   Nvram    Config
                                 ------------------------
                                 0    Success
                                 
                                 Power-cycling the unit(s).
                                 ....

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \