Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

interface range macro name

Run the interface-range macro to automatically configure the pre-defined range of interfaces.

Syntax

interface range macro name

Parameters

name

Enter the name of an existing macro.

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Example (Single Range)

This example shows the macro named test that was defined earlier.

Dell(config)#interface range macro test
                                             Dell(config-if-range-te-0/0-3,te-5/0-8)#

Related Commands

interface range — configures a range of command (bulk configuration).

interface range macro (define) — defines a macro for an interface range (bulk configuration).