Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

reset stack-unit

Reset any designated stack member except the management unit (master unit).

Syntax

reset stack-unit 0–5 hard

Parameters

0–5	Enter the stack member unit identifier of the stack member to reset.
hard	Reset the stack unit if the unit is in a problem state.

Defaults

none

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6.(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

This command is supported on the M I/O, FN410S, and FN410T Aggregators

Resetting the management unit is not allowed and an error message displays if you try to do so. Resetting is a soft reboot, including flushing the forwarding tables.

You can run this command directly on the stack standby unit (Standby Master) to reset the standby. You cannot reset any other unit from the standby unit

Example

Dell#show system brief
                                             Stack MAC : 00:1e:c9:f1:00:9b
                                             -- Stack Info --
                                             Unit    UnitType      Status      ReqTyp        CurTyp         Version      Ports
                                             ---------------------------------------------------------------------------------
                                             ---
                                             0       Management     online    I/O-Aggregator I/O-Aggregator    8-3-17-46   56
                                             1       Standby        online    I/O-Aggregator I/O-Aggregator    8-3-17-46   56
                                             2       Member      not present
                                             3       Member      not present
                                             4       Member      not present
                                             5       Member      not present
                                             Dell#
                                             Dell#reset stack-unit 0 >>>Resetting master not allowed
                                             % Error: Reset of master unit is not allowed.
                                             Dell#
                                             Dell#reset stack-unit 1
                                             Dell#01:02:00: %STKUNIT0-M:CP %CHMGR-5-STACKUNIT_RESET: Stack unit 1 being reset
                                             01:02:00: %STKUNIT0-M:CP %IFMGR-1-DEL_PORT: Removed port: Te 1/1-32,41-56
                                             01:02:00: %STKUNIT0-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 1 down - reset
                                             01:02:00: %STKUNIT1-S:CP %IFMGR-1-DEL_PORT: Removed port: Te 1/1-32,41-56
                                             01:02:05: %I/O-Aggregator:0 %IFAGT-5-STACK_PORT_LINK_DOWN: Changed stack port
                                             state to down: 0/10
                                             01:02:11: %STKUNIT0-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit is
                                             not present
                                             Dell#01:02:12: %STKUNIT0-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 1 down - card
                                             removed

Related Commands

reload— reboots the system.