Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip msdp sa-limit

Configure the upper limit of source-active (SA) entries in SA-cache.

Syntax

ip msdp sa-limit number

To return to the default, use the no ip msdp sa-limit number command.

Parameters

number

Enter the maximum number of SA entries in SA-cache. The range is from 0 to 40000.

Defaults

50000

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The system counts the SA messages originated by itself and those messages received from the MSDP peers. When the total SA messages reach this limit, the subsequent SA messages are dropped (even if they pass RPF checking and policy checking).

If the total number of SA messages is already larger than the limit when this command is applied, those SA messages that are already in the software continue to be accepted. To enforce the limit in such situation, use the clear ip msdp sa-cache command.

Related Commands

ip msdp peer — configures the MSDP peer.

clear ip msdp peer — clears the MSDP peer.

show ip msdp — displays the MSDP information