Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip route summary

View a table summarizing the IP routes in the switch.

Syntax

show ip route summary

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip route summary shown in the following example.

Column Heading	Description
Route Source	Identifies how the route is configured in the system.
Active Routes	Identifies the best route if a route is learned from two protocol sources.
Non-active Routes	Identifies the back-up routes when a route is learned by two different protocols. If the best route or active route goes down, the non-active route becomes the best route.
ospf 100	If routing protocols (OSPF, RIP) are configured and routes are advertised, then information on those routes is displayed.
Total 1388 active...	Displays the number of active and non-active routes and the memory usage of those routes. If there are no routes configured in the the system, this line does not appear.

Example

Dell>show ip route summary
                                             
                                             Route Source   Active Routes   Non-active Routes
                                             connected      17              0
                                             static         3               0
                                             ospf 100       1368            2
                                             Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
                                             Total          1388            2
                                             Total 1388 active route(s) using 222440 bytes
                                             Total 2 non-active route(s) using 128 bytes
                                             Dell>

Related Commands

show ip route — displays information about the routes found in the switch.