Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show system stack-ports

Display information about the stacking ports on all switches in the FN I/O Aggregator switch stack..

Syntax

show system stack-ports [status | topology]

Parameters

status	(OPTIONAL) Enter the keyword `status` to display the command output without the Connection field.
topology	(OPTIONAL) Enter the keyword `topology` to limit the table to just the Interface and Connection fields.

Defaults

none

Command Modes

EXEC
EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6.(0.0)	Supported on the FN I/O Aggregator.

Usage Information

This command is supported on the M I/O, FN410S, and FN410T Aggregators.

The following describes the show interfaces command shown in the following example.

Field	Description
Topology	Lists the topology of stack ports connected: Ring, Daisy chain, or Standalone.
Interface	The unit/port ID of the connected stack port on this unit.
Link Speed	Link Speed of the stack port (10) in Gb/s.
Admin Status	The only currently listed status is Up.
Connection	The stack port ID to which this unit’s stack port is connected.

Example

Dell# show system stack-ports
                                             Topology: Ring
                                             
                                             Interface Connection Link Speed    Admin  Link   Trunk
                                             (Gb/s)        Status Status Group
                                             0/9                   10             up    down
                                             0/10         1/10    10             up     up
                                             1/9                  10             up    down
                                             1/10         0/10     10             up     up
                                             Dell#

Example (Status)

Dell# show system stack-ports status
                                             Topology: Daisy chain
                                             Interface Link Speed   Admin   Link    Trunk
                                             (Gb/s)       Status  Status  Group
                                             0/9        10           up   down
                                             0/10        10           up    up
                                             1/9        10           up   down
                                             1/10        10           up    up

Example (Topology)

Dell# show system stack-ports topology
                                             Topology: Daisy chain
                                             
                                             Interface Connection Trunk
                                             Group
                                             
                                             0/9
                                             0/9       1/10
                                             1/10
                                             1/10       0/10
                                             Dell	#

Related Commands

power-cycle stack-unit—resets the designated stack member.

show diag — displays the data plane or management plane input and output statistics of the designated component of the designated stack member.

show system—displays the current status of all stack members or a specific member.