Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

permit

Configure a permit rule. A permit rule excludes the matching packets from PBR classification and routes them using conventional routing.

Syntax

permit { ip-protocol-number | protocol-type} { source mask | any | host ip-address} { destination mask | any | host ip-address} [ bit] [operators]

To remove the rule, use one of the following:

If you know the filter sequence number, use the no seq sequence-number syntax command.
You can also use the no permit { ip-protocol-number | protocol-type} { source mask | any | host ip-address} { destination mask | any | host ip-address} [ bit] [operators] command.

Parameters

ip-protocol-number	Enter a number from 0 to 255 for the protocol identified in the IP protocol header.
protocol-type	Enter one of the following keywords as the protocol type: `icmp` for internet control message protocol `ip` for any internet protocol `tcp` for transmission control protocol `udp` for user datagram protocol
source	Enter the IP address of the network or host from which the packets were sent.
mask	Enter a network mask in /prefix format (/x).
any	Enter the keyword `any` to specify that all traffic is subject to the filter.
host ip-address	Enter the keyword `host` then the IP address to specify a host IP address.
destination	Enter the IP address of the network or host to which the packets are sent.
bit	(OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags: `ack` = acknowledgement `fin` = finish (no more data from the user) `psh` = push function `rst` = reset the connection `syn` = synchronize sequence number `urg` = urgent field
operator	(OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: `eq` = equal to `neq` = not equal to `gt` = greater than `lt`= less than `range` = inclusive range of ports (you must specify two ports for the `port`command parameter.)

Defaults

none

Command Modes

REDIRECT-LIST

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1	Introduced on the C-Series and S-Series.
8.4.2.0	Introduced on the E-Series TeraScale.
7.5.1.0	Introduced on the E-Series ExaScale.