Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ospf dead-interval

Set the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead.

Syntax

ip ospf dead-interval seconds

To return to the default values, use the no ip ospf dead-interval command.

Parameters

seconds

Enter the number of seconds for the interval. The range is from 1 to 65535. The default is 40 seconds.

Defaults

40 seconds

Command Modes

INTERFACE

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

By default, the dead interval is four times the default hello-interval.

Related Commands

ip ospf hello-interval — sets the time interval between the hello packets.