Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 pim dr-priority

Change the designated router (DR) priority for the IPv6 interface.

Syntax

ipv6 pim dr-priority priority-value

To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.

Parameters

priority-value

Enter a number. Preference is given to larger/higher number. The range is from 0 to 4294967294. The default is 1.

Defaults

1

Command Modes

INTERFACE

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router.