Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show interfaces dampening

Display interface dampening information.

Syntax

show interfaces dampening [[ interface] [summary] [detail]]

Parameters

interface	(Optional) Enter one of the following keywords and slot/port or number information: For a Port Channel interface, enter the keywords `port-channel` then a number. The range is from 1 to 128. For a 10-Gigabit Ethernet interface, enter the keyword `TenGigabitEthernet` then the slot/port information. NOTE: This command also enables you to view information corresponding to a range of ports. However, for Open Networking (ON) platforms the notation for specifying port range in the command is different from how you specify in non-ON platforms. For non-ON platforms, you can specify multiple ports as `slot/port-range`. For example, if you want to display information corresponding to all ports between 1 and 4, specify the port range as `show interfaces interface-type 1/1 - 4`. For ON platforms, you can specify multiple ports as `slot/port/[subport] - slot/port/[subpot]`. For example, if you want to display information corresponding to all ports between 1 and 4, specify the port range as `show interfaces interface-type 1/1/1 - 1/4/1`.
summary	(OPTIONAL) Enter the keyword `summary` to display the current summary of dampening data, including the number of interfaces configured and the number of interfaces suppressed, if any.
detail	(OPTIONAL) Enter the keyword `detail` to display detailed interface dampening data.

Defaults

none

Command Modes

EXEC

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM and added support to display the interface configurations corresponding to a range of ports.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell#show interfaces dampening
                                             Interface Supp   Flaps Penalty Half-Life Reuse Suppress Max-Sup
                                             State
                                             Te 3/2    Up     0     0        20       800   4500     120
                                             Te 3/8    Up     0     0        5        750   2500     20
                                             Dell#

Related Commands

dampening — configures dampening on an interface.

show interfaces — displays information on a specific physical interface or virtual interface.

show interfaces configured — displays any interface with a non-default configuration.