Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

port-channel failover-group

To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.

Syntax

port-channel failover-group

To remove all LAG failover groups, use the no port-channel failover-group command.

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

This feature groups two LAGs to work in tandem as a supergroup. For example, if one LAG goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For more information, refer to the Port Channel chapter in the Dell Networking OS Configuration Guide.

Related Command

group — groups two LAGs in a supergroup (“fate-sharing group”).

show interfaces port-channel — displays information on configured Port Channel groups.