Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

timer

Set the hello interval or dead interval for the Ring control packets.

Syntax

timer {hello-interval milliseconds}| {dead-interval milliseconds}

To remove the timer, use the no timer {hello-interval [ milliseconds]}| {dead-interval milliseconds} command.

Parameters

hello-interval milliseconds	Enter the keyword `hello-interval` then the time, in milliseconds, to set the hello interval of the control packets. The milliseconds must be entered in increments of 50 millisecond; for example, 50, 100, 150, and so on. If an invalid value is entered, an error message is generated. The range is from 50 to 2000 ms. Default: 500 ms.
dead-interval milliseconds	Enter the keyword `dead-interval` then the time, in milliseconds, to set the dead interval of the control packets. The range is from 50 to 6000 ms. Default: 1500 ms. NOTE: The configured dead interval must be at least three times the hello interval.

Defaults

500 ms for hello-interval milliseconds
1500 ms for dead-interval milliseconds

Command Modes

CONFIGURATION (conf-frrp)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The hello interval command is the interval at which ring frames are generated from the primary interface of the master node. The dead interval command is the time that elapses before a time-out occurs.