Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

router bgp

To configure and enable BGP, enter ROUTER BGP mode.

Syntax

router bgp as-number

To disable BGP, use the no router bgp as-number command.

Parameters

as-number

Enter the AS number. The range is from 1 to 65535 (2 byte), from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted format).

Defaults

Not enabled.

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:

% Error: No router id
                                             configured

Example

Dell(conf)#router bgp 3
                                             Dell(conf-router_bgp)#