Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show ip pim tib

View the PIM tree information base (TIB).

Syntax

show ip pim tib [ group-address [ source-address]]

Parameters

group-address	(OPTIONAL) Enter the group address in dotted decimal format (A.B.C.D).
source-address	(OPTIONAL) Enter the source address in dotted decimal format (A.B.C.D).

Command Modes

EXEC
EXEC Privilege

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The following describes the show ip pim tib command shown in the following example.

Field	Description
(S, G)	Displays the entry in the multicast PIM database.
uptime	Displays the amount of time the entry has been in the PIM route table.
expires	Displays the amount of time until the entry expires and is removed from the database.
RP	Displays the IP address of the RP/source for this entry.
flags	List the flags to define the entries: D = PIM Dense Mode S = PIM Sparse Mode C = directly connected L = local to the multicast group P = route was pruned R = the forwarding entry is pointing toward the RP F = Dell Networking OS is registering this entry for a multicast source T = packets were received via Shortest Tree Path J = first packet from the last hop router is received and the entry is ready to switch to SPT K = acknowledge pending state
Incoming interface	Displays the reverse path forwarding (RPF) interface towards the RP/ source.
RPF neighbor	Displays the next hop from this interface towards the RP/source.
Outgoing interface list:	Lists the interfaces that meet one of the following criteria: a directly connect member of the Group statically configured member of the Group received a (*,G) Join message

Example

Dell#show ip pim tib
                                             
                                             PIM Multicast Routing Table
                                             Flags:D- Dense, S- Sparse, C- Connected, L- Local, P- Pruned,
                                             R- RP-bit set, F- Register flag, T- SPT-bit set, J- Join SPT,
                                             M- MSDP created entry, A- Candidate for MSDP Advertisement,
                                             K- Ack-Pending State
                                             Timers: Uptime/Expires
                                             Interface state: Interface, next-Hop, State/Mode
                                             
                                             (*, 226.1.1.1), uptime 01:29:19, expires 00:00:52, RP 10.211.2.1, flags: SCJ
                                             Incoming interface: TenGigabitEthernet 0/2, RPF neighbor 10.211.1.2
                                             Outgoing interface list:
                                             TenGigabitEthernet 0/8
                                             
                                             (*, 226.1.1.2), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
                                             Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
                                             Outgoing interface list:
                                             TenGigabitEthernet 0/8
                                             
                                             (*, 226.1.1.3), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
                                             Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
                                             Outgoing interface list:
                                             TenGigabitEthernet 0/8
                                             
                                             (*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP 10.211.2.1, flags: SCJ
                                             Incoming interface: TenGigabitEthernet 1/2, RPF neighbor 10.211.1.2
                                             Outgoing interface list:
                                             TenGigabitEthernet 0/8