Zu den Hauptinhalten

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip udp-broadcast-address

Configure an IP UDP address for broadcast.

Syntax

ip udp-broadcast-address address

To delete the configuration, use the no ip udp-broadcast-address address command.

Parameters

address

Enter an IP broadcast address in dotted decimal format (A.B.C.D).

Defaults

Not configured.

Command Modes

INTERFACE (config-if)

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Enter an IP broadcast address in dotted decimal format (A.B.C.D).

Usage Information

When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is configured using this command, the outgoing packet’s IP destination address is replaced with the configured broadcast address.

Related Commands

debug ip udp-helper — enables debug and displays the debug information on a console.

show ip udp-helper — displays the configured UDP helpers on all interfaces.