Secure Connect Gateway 5.x — Virtual Edition User's Guide

Add a data storage device

1. Go to Device management > Manage devices > Devices > Add device.
2. From the Device type list, select Data Storage.
3. Select the storage type.
   If you select the Customer Management Station, the secure connect gateway serial number is automatically displayed.
4. To add an EqualLogic or PowerVault MD3 or ME4 device, see Add an EqualLogic or PowerVault MD3 or ME4 device.
5. To add a Dell Compellent, Fluid FS, or a Dell ML3 tape library, see Add a Dell Compellent, Fluid FS device, or a Dell ML3 tape library.
6. If you selected any other storage type, perform the following steps. For information about the other data storage models that can be added from secure connect gateway user interface, see Methods of adding devices.
   1. Enter the IP address and serial number of the device.
   2. Select the device extension.
   3. Click Next.
   The device is discovered, and then the Devices page is displayed with the device details.

   NOTE:You cannot use other features in secure connect gateway during the device discovery process.

   NOTE:To enable remote support and remote actions capabilities for these models, configure the settings using Policy Manager or contact Dell technical support.