- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Configure security certificates
About this task
A security certificate allows you to:
- Securely access the secure connect gateway user interface or perform any tasks in secure connect gateway through port 5700.
- Securely connect to the backend using RESTful protocol through port 9443.
You can upload certificates in the PEM, P12, or PFX formats. If you upload a certificate in PEM format, you must also upload the key in KEY format as a separate file. The PEM file must have the certificate chain that includes the certificate, intermediate, and root certificate authority. You can upload separate certificates for port 5700 and 9443 or a common certificate for both the ports.
Steps
- Go to .
-
Select the port number for which the certificate is applicable for and then upload the certificate and key file, if applicable.
NOTE:If you upload a certificate in PEM format, you must also upload the key in KEY format as a separate file.
- If you upload the certificate in PEM format, enter the passphrase.
- Click Apply.
-
Click
Restart now to restart secure connect gateway.
- You are logged out of the secure connect gateway user interface.
- The security certificates are applied to your instance.
- The certificate name and expiry information are displayed in the Certificate management section.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\