- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Configuration viewer
The Configuration Viewer displays the telemetry collected by secure connect gateway from your devices.
NOTE:The
Configuration Viewer does not display the telemetry that is collected from storage devices with Fluid File System (FluidFS).
The Configuration Viewer displays information under various categories and sub categories in a tabbed format. The Summary section displays the following information:
- The telemetry settings in secure connect gateway at the time of the collection.
- Summary of errors that were detected in the collected telemetry.
- Brief information about the device.
If you have disabled the collection of identity information from devices, the identity information such as hostname, IP address, and so on, are replaced by tokenized values. The tokenized values are represented as TOKENn—for example, TOKEN0, TOKEN1, or TOKEN2.
For a list of items that may be reported in collections from a server, see Items reported in periodic collections from servers.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\