- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Manually configure alert destination using the script file for a server running Linux operating system
Prerequisites
- Ensure that Net-SNMP is installed on the system. See Install Net-SNMP on a server running Linux operating system.
- Ensure that you have root privileges on the device.
Steps
- In the install directory on the local system, go to the /opt/dell/secureconnectgateway/scripts folder.
- Copy and paste LinuxSNMPConfig.sh in the desired location.
- Log in to the terminal window using root privileges.
- Run the script file on the device using the following syntax: sh LinuxSNMPConfig.sh -d <IP address of the local system>. For example, sh LinuxSNMPConfig.sh -d 10.10.10.10.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\