- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Device correlation
You can add a server in secure connect gateway by using the host operating system IP address and iDRAC IP address of the device. In such a case, the Devices page displays two separate listings for the same device. Secure connect gateway receives alerts from the device through both the operating system and the iDRAC. However, for operational purposes, the operating system IP address and iDRAC IP address are correlated and considered as a single device. For correlated devices:
- The alerts from the operating system and the iDRAC are correlated and a service request is created for the Service Tag of the device.
- When telemetry is collected, the Devices page displays the same status for both the listings.
- For a manually initiated collection, the telemetry is collected through the selected device listing on the Devices page. For example, if the operating system listing is selected, telemetry is collected only through the operating system. However, if secure connect gateway is unable to connect to the device by using the operating system IP address, the telemetry is collected through the iDRAC.
- During periodic collections and collections performed when a service request is created, the telemetry is collected through the operating system. However, if secure connect gateway is unable to connect to the device by using the operating system IP address, the telemetry is collected through the iDRAC.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\