- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Document purpose
This document provides information about the minimum system and network requirements, deployment instructions, and features available in secure connect gateway. For information about other documents available for secure connect gateway, see Secure Connect Gateway resources.
In this document, the term local system refers to the secure connect gateway virtual appliance; remote device refers to device in your environment; backend refers to Dell Technologies.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\