Manually configure alert destination of a networking device
About this task
NOTE:The steps to configure the alert destination of networking devices may vary based on the model. For information about configuring the alert destination of a specific model, see the device-specific documentation.
Steps
Log in to the device using a terminal emulator such as PuTTY.
Run
configure.
Run
snmp-server host <IP address of the local system> traps version 2.
To verify if the alert destination is configured successfully, run
show running-config snmp.
The list of alert destinations that are configured on the device is displayed.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\