- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Configure API settings
About this task
NOTE:You can perform a maximum of 10 operations such as adding devices and collecting telemetry in parallel. Before you query the operation status and operation ID, ensure that there is a minimum delay of five seconds.
Steps
- Go to .
- Select the Enable API interfaces for this gateway check box and click Apply.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\