- Notes, cautions, and warnings
- Introduction
- New and enhanced features
- Dashboard
- Devices
- Methods of adding devices
- Add a chassis
- Add an iDRAC
- Add a networking device
- Add a server or hypervisor
- Add a software
- Add a virtual machine
- Add a converged or hyperconverged infrastructure appliance
- Add a data storage device
- Add a direct liquid cooling device
- Add a data protection device
- Deep discovery
- Maintenance mode overview
- Inventory validation
- Device correlation
- Enable or disable remote access
- Device discovery rules
- Adapters
- Device groups
- Device credentials and credential profiles
- Service requests
- Telemetry
- Extensions
- Audits
- Configuring Secure Connect Gateway settings
- Configuring alert and event settings
- Updating Secure Connect Gateway
- Secure Connect Gateway resources
- Contacting Dell Technologies
Secure Connect Gateway 5.x — Virtual Edition User's Guide
Manually configure alert destination by accessing the SNMP trap service for a server running Linux operating system
Steps
- Log in to the terminal window using root privileges.
- Run rpm -qa | grep snmp, and ensure that the net-snmp package is installed.
- Run cd /etc/snmp to go to the SNMP directory.
- Open snmpd.conf in the VI editor (vi snmpd.conf).
- Search snmpd.conf for # group context sec.model sec.level prefix read write notif and ensure that the values for read, write, and notif are set to all.
- At the end of the snmpd.conf file, before Further Information, add an entry in the following format: Trapsink <IP address of the local system> <community string>, for example, trapsink 10.94.174.190 public.
- Run service snmpd restart to restart the SNMP service.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\