Dell PowerEdge R660 Installation and Service Manual

Installing EDSFF E3.S PERC module and battery tray

Prerequisites

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in Before working inside your system.
Remove the drive backplane cover.
If installed, remove the air shroud.
Route the cable properly to prevent the cable from being pinched or crimped.

Steps

Align and install PERC card to the guides on the front PERC tray.
Align and Install the PERC shroud on the PERC card.
Using a Phillips #2 screwdriver, tighten the four screws to secure the PERC shroud to the PERC tray.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 1. Installing the H965 PERC module
Slide the PERC module until the module is connected to the drive backplane.
Using a Phillips #2 screwdriver, tighten the screws on the PERC module.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 2. Installing the PERC battery tray
Align and slide the PERC module and drive backplane to the chassis and ensure it engages with the guiding hole of the chassis bracket.
Using a Phillips #2 screwdriver, replace the two screws on the chassis bracket.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 3. Installing the PERC battery tray
If removed, install battery holder, by placing the PERC battery holder between the E3.S backplanes.
Using a Phillips #2 screwdriver, tighten the captive screw on the PERC battery holder.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 4. Installing the PERC battery holder
Align and insert the hooks on the battery to the holes on the battery holder and press down the battery to install the PERC battery on to the holder.
Route the power cable and connect it to the PERC power connector.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 5. Installing the PERC battery