Dell PowerEdge R660 Installation and Service Manual

Removing the BOSS-N1 module

Pull and lift the BOSS-N1 card carrier retention latch lock to open.
Slide the BOSS-N1 card carrier out.
Figure 1. Removing the BOSS-N1 card carrier
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screw that secures the M.2 NVMe SSD to the BOSS-N1 card carrier.
Slide the M.2 NVMe SSD out from the BOSS-N1 card carrier.
Figure 2. Removing the M.2 NVMe SSD
Press the metal clip to remove the BOSS-N1 signal cable from the system board.
Disconnect the BOSS-N1 power cable from the system board.
Using the Phillips #1 screwdriver remove the M3 x 0.5 x 4.5 mm screws that secures the BOSS-N1 module .
Slide the BOSS-N1 module towards the front of the chassis and lift the module.
Figure 3. Removing the BOSS-N1 module
Press the metal clip to remove the BOSS-N1 signal cable from the BOSS-N1 module.
Remove the power cable from the BOSS-N1 module.
Figure 4. Removing the BOSS-N1 power and signal cable from the BOSS-N1 module
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Using the Phillips #1 screwdriver, remove the M3 x 0.5 x 4.5 mm screw that secures the BOSS- N1 cover on the BOSS-N1 controller card module. Slide the BOSS-N1 cover out from the BOSS-N1 controller card module.
Figure 5. Removing the BOSS-N1 cover