Dell PowerEdge R660 Installation and Service Manual

Installing the front mounting front PERC module

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in Before working inside your system.
Remove the drive backplane cover.
If installed, remove the air shroud.
Route the cable properly to prevent the cable from being pinched or crimped. For detailed cable routing instructions, see the cable routing section.

Align the holes on front PERC card to the guides on the PERC mounting tray.
Install the front PERC card on the PERC mounting tray.
Figure 1. Installing the front PERC card to the PERC mounting tray
Align and install the battery PERC shroud on the front PERC.card.
Connect the battery power cable to the front PERC card.
Using a Phillips #2 screwdriver, replace the four screws to secure the battery PERC shroud to the front PERC card.
Figure 2. Installing the battery PERC shroud
Connect PERC power cable to the front PERC card.
Align the holes on the PERC power cable bracket with the holes on the PERC mounting tray.
Using a Phillips #2 screwdriver, replace the two screws on the PERC power cable bracket.
Align the PERC mounting tray until the tray touches the guide slots in the system. Slide the front PERC card towards the lock to secure it and ensure the plunger is engaged in to the hole on the system.
Connect the power cable to the backplane. For detailed cable routing instructions, see the cable routing section.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 3. Installing the front mounting front PERC card