Dell PowerEdge R660 Installation and Service Manual

Removing the Direct Liquid Cooling module

1. Using a Phillips #2 screw driver, loosen the captive screw on the DLC ring holder.
2. Tilt the DLC ring holder to loosen the DLC tubes.
3. Disconnect the DLC leak detection cable from the LC RIO board.
4. Remove the DLC tubes from the clip and LC RIO board.
5. Slightly lift the DLC tubes surrounding the DIMM slots.
6. Ensure all four anti-tilt wires are in the locked position (outward position), and then using a Torx T30 screwdriver, loosen the captive nuts on the DLC module in the order that is mentioned below:
   1. Loosen the first nut three turns.
   2. Loosen the nut diagonally opposite to the nut you loosened first.
   3. Repeat the procedure for the remaining two nuts.
   4. Return to the first nut and loosen it completely.
   NOTE:Ensure that the anti-tilt wires on the DLC module are in locked position when loosening the captive nuts.
7. Set the anti-tilt wires on the DLC module to the unlock position and lift the DLC module from the system.
   NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.