跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R660 Installation and Service Manual

PDF

Removing expansion card from the expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in theSafety instructions .
  2. Follow the procedure listed in Before working inside your system .
  3. If applicable, disconnect the cables from the expansion card.

Steps

  1. Pull and lift the expansion card retention latch lock to open.
    NOTE:Pull the card holder before removing the card from the riser.
  2. Hold the expansion card by the edges and pull the card until the card edge connector disengages from the expansion card connector on the riser.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing expansion card from the expansion card riser
    This image shows how to open the card holder.
    Figure 2. Removing expansion card from the expansion card riser
    This image shows how to open the card holder.
  3. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
    Figure 3. Installing the filler bracket
    This image shows how to install a filler bracket into the expansion card riser.
    This image shows riser 2 filler installation.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\