Dell PowerEdge R660 Installation and Service Manual

Removing the side wall bracket

There are side wall brackets on either side of the system. The procedure to remove is similar.

Prerequisites

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in the Before working inside your system..
If installed, remove the air shroud.
Remove the cooling fan.

NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cables properly when you replace them to prevent the cables from being pinched or crimped.

NOTE:There are two different right side brackets - one with foam and one without. Installation and removal procedure is the same for both these brackets.

Steps

Lift the side wall bracket from the chassis.
Open the side wall cable holder, remove the cables from the side wall cable holder.
Figure 1. Removing the left side wall bracket
Figure 2. Removing the right side wall bracket

Next steps

Replace the side wall bracket.

歡迎

歡迎來到 Dell

Dell PowerEdge R660 Installation and Service Manual

Removing the side wall bracket

Prerequisites

Steps

Next steps

對此內容評分