跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R660 Installation and Service Manual

PDF

Replacing the system battery

Prerequisites

WARNING:There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the Safety instructions. that came with your system for more information.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. If applicable, disconnect the power or data cables from the expansion cards.
  4. remove the expansion card riser.

Steps

  1. Press and hold the battery socket retention latch, for the battery to pop out.
    CAUTION:To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
    NOTE:If the battery does not pop out, then lift it out of the socket.
    Figure 1. Removing the system battery
    This image shows how to remove a system battery.
  2. To install a new system battery, hold the battery with the positive side facing up at an angle and slide it under the battery socket latch.
  3. Press the battery into the connector until it snaps into place.
    Figure 2. Installing the system battery
    This image shows how to remove a system battery.

Next steps

  1. install the expansion card riser.
  2. If applicable, connect the cables to one or more expansion cards.
  3. Follow the procedure listed in After working inside your system.
  4. Confirm that the battery is operating properly, by performing the following steps:
    1. Enter the System Setup, while booting, by pressing F2.
    2. Enter the correct time and date in the System Setup Time and Date fields.
    3. Exit the System Setup.
    4. To test the newly installed battery, remove the system from the enclosure for at least an hour.
    5. Reinstall the system into the enclosure after an hour.
    6. Enter the System Setup and if the time and date are still incorrect, see Getting help section.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\