Dell PowerEdge R660 Installation and Service Manual

Removing the rear mounting front PERC module

Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
Slide the front PERC module to disengage from the connector on the drive backplane.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 1. Removing the rear mounting front PERC module
Using a Phillips #2 screwdriver, remove the three screws securing the front PERC module bracket to the drive backplane.
Disconnect the battery power cable from the front PERC card.
Tilt and lift the battery holder assembly from the front PERC shroud.
NOTE:Remove the battery cable from the front PERC shroud cable holder.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 2. Removing the battery holder assembly from the PERC shroud
Press and remove the battery from the battery holder.
Figure 3. Removing the battery from the battery holder
Using a Phillips #2 screwdriver, remove the four screws on the front PERC shroud.
Remove the front PERC shroud from the PERC.card.
Remove the front PERC card from the PERC tray.
Figure 4. Removing the front PERC card
Remove the front PERC module bracket away from the drive backplane.
Figure 5. Removing the rear mounting front PERC module bracket