Dell PowerEdge R660 Installation and Service Manual

Removing the EDSFF E3.S PERC module and battery tray

Prerequisites

Follow the safety guidelines listed in the Safety instructions.
Follow the procedure listed in Before working inside your system.
Remove the drive backplane cover.
If installed, remove the air shroud.
Disconnect all the cables, observe the cable routing.

Steps

Disconnect the power cable from the PERC power connector, unroute the power cables.
Lift the battery at an angle and release the battery hooks from the holes on the battery holder and remove it from the PERC battery holder.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 1. Removing the PERC battery
Using a Phillips #2 screwdriver, loosen the captive screw on the PERC battery holder.
Remove the PERC battery holder out of the system.
NOTE: EDSFF E3.S PERC module can be replaced without removing the battery holder.
NOTE:Two batteries can be installed on the battery holder.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 2. Removing the PERC battery holder
Using a Phillips #2 screwdriver, remove the screws on the chassis bracket.
Slide and lift the PERC module and drive backplane to disengage from the chassis.
Figure 3. Removing the PERC module

NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Using a Phillips #2 screwdriver, remove the two screws on the PERC module.
Slide the PERC module to disengage from the connector on the drive backplane.
Figure 4. Removing the PERC module
Using a Phillips #2 screwdriver, remove the four screws on the front PERC shroud.
Remove the PERC shroud from the PERC.card.
Remove the PERC card from the PERC tray.
NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 5. Removing the PERC card