跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R660 Installation and Service Manual

PDF

Installing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the drive backplane cover.
  4. If installed, remove the air shroud.

Steps

  1. Align and slide the right control panel in the slot on the system.
  2. Route the right control panel cable through the side wall of the system. Close the cable latch and slide the cable into the clip.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  3. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
  4. Connect the right control panel cable to the connector on the system board.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the right control panel
    This image shows how to install the right control panel.

Next steps

  1. Install the drive backplane cover.
  2. If applicable, replace the air shroud.
  3. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\