跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R660 Installation and Service Manual

PDF

Installing the LOM card (optional),MIC card, and rear I/O board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the system board.
NOTE:The procedure to install the liquid cooling rear I/O board and rear I/O boards is same.

Steps

  1. Align the connectors and slots on the LAN on Motherboard (LOM) card, Management Interface card (MIC), or rear I/O board with the connector and standoffs on the system board.
  2. Press the LOM card, MIC card, or rear I/O board until firmly seated on the system board connector.
  3. Using a Phillips #2 screwdriver, secure the LOM card, MIC card or rear I/O board to the system board with screws.
    Figure 1. Installing the LOM card and rear I/O board
    This image shows installing the LOM card and rear I/O board.
    Figure 2. Installing the LOM card and Liquid cooling rear I/O board
    This image shows Installing the liquid cooling rear I/O board
    Figure 3. Installing the MIC card
    Tihis image shows Installing MIC card
    NOTE:MIC is card is only available in the system that supports Dell DPU cards.

Next steps

  1. Install the system board.
  2. Follow the procedure listed in After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\