跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge R660 Installation and Service Manual

PDF

Installing the VGA module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. If installed, remove the front bezel.
  4. Remove the drive backplane cover.
  5. If installed, remove the air shroud.
  6. Disconnect the VGA cable from the connector on the system board.
  7. Pull the right control panel cable from the clip and move it to clear the path of the VGA module screw.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cables properly when you replace it to prevent the cables from being pinched or crimped.

Steps

  1. Route the VGA cable through the slot on the front of the system and slide the VGA module into the slot.
  2. Align the hole on the module with the screw hole on the system.
  3. Using the Phillips #2 screwdriver, secure the VGA module to the system with the screw.
  4. Connect the VGA cable from the connector on the system board
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the VGA module
    This image shows how to install the VGA module.

Next steps

  1. Route the VGA cable, close the cable latch, and connect the VGA cable to the connector on the system board.
  2. If removed, replace the air shroud.
  3. Install the drive backplane cover
  4. If installed, install the front bezel.
  5. Follow the procedure listed in the After working inside your system.

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\