Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Assigning a loopback interface to a non-default VRF instance

After creating a non-default VRF instance you can associate a loopback interface to the VRF instance that you created.

To assign a loopback interface to a non-default VRF, perform the following steps:

  1. Enter the loopback interface that you want to assign to a non-default VRF instance.
    CONFIGURATION
    interface loopback 5
  2. Assign the interface to a non-default VRF.
    INTERFACE CONFIGURATION
    ip vrf forwarding vrf-test
    Before assigning a n interface to a VRF instance, ensure that no IP address is configured on the interface.
  3. Assign an IPv4 address to the interface.
    INTERFACE CONFIGURATION
    ip address 10.1.1.1/24
  4. Assign an IPv6 address to the interface.
    INTERFACE CONFIGURATION
    ipv6 address 1::1/64
    You can also auto configure an IPv6 address using the ipv6 address autoconfig command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\