Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

sync-e wait-to-restore-time

Configures the wait-to-restore time period for the failed clock sources.

Syntax
[no] sync-e wait-to-restore-time seconds
Parameters
seconds—Enter the wait-to-restore time interval in seconds, from 0 to 720.
Default
300
Command Mode
  • CONFIGURATION
  • INTERFACE CONFIGURATION
Security and Access
Netadmin and sysadmin
Usage Information
This command configures the time period for a previously failed synchronization source to be up before it is again considered selection process. For an input clock to transition out of the signal fail state, it must be fault-free for the wait-to-restore time. Use the clear sync-e wait-restore-time command to clear the wait-to-restore timer. The interface-level wait-to-restore value takes precedence over the global wait-to-restore value. The no form of this command removes the configuration.
Example 
OS10(config)# sync-e wait-to-restore-time 3
Supported Releases
10.5.2.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\