Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

seq permit (MAC)

Assigns a sequence number to permit MAC addresses while creating a filter.

Syntax
seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | count [byte] | vlan]
Parameters
  • sequence-number — Enter the sequence number to identify the route-map for editing and sequencing, from 1 to 16777214.
  • nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets were sent.
  • 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies.
  • any — (Optional) Set all routes to be subject to the filter:
    • protocol-number — (Optional) Enter the protocol number identified in the MAC header, from 600 to ffff.
    • capture — (Optional) Enter the capture packets the filter processes.
    • cos — (Optional) Enter the CoS value, from 0 to 7.
    • count — (Optional) Enter the count packets the filter processes.
    • byte — (Optional) Enter the count bytes the filter processes.
    • vlan — (Optional) Enter the VLAN number, from 1 to 4093.
Default
Not configured
Command Mode
MAC-ACL
Usage Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7
OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\