Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

vlt delay-restore orphan-port ignore vlti-failure

Considers or ignores VLTi failures for delay-restore orphan port.

Syntax
vlt delay-restore orphan-port ignore vlti-failure
To disable the delay-restore orphan port configuration, enter the no delay-restore orphan-port ignore vlti-failure command.
Parameters
None.
Default
Disabled
Command Mode
INTERFACE CONFIGURATION MODE
Usage Information
Use the range command to enable delay-restore orphan ports on all interfaces or on selected range of interfaces.
Example 
ENABLE/DISABLE ON PHYSICAL INTERFACE:

OS10(config)# interface ethernet 1/1/1

OS10(conf-if-eth1/1/1)# vlt delay-restore orphan-port ignore vlti-failure

OS10(conf-if-eth1/1/1)# no vlt delay-restore orphan-port ignore vlti-failure

 

ENABLE/DISABLE ON PORT-CHANNEL:

OS10(config)# interface port-channel 1

OS10(conf-if-po-1)# vlt delay-restore orphan-port ignore-vlti-failure

OS10(conf-if-po-1)# no vlt delay-restore orphan-port ignore-vlti-failure

 

ENABLE ON RANGE OF ETHERNET INTERFACES/PORT-CHANNELS:

OS10(config)# interface range ethernet 1/1/1-1/1/10

OS10(conf-range-eth1/1/1-1/1/10)# vlt delay-restore orphan-port ignore-vlti-failure

OS10(config)# interface range port-channel 1-10

OS10(conf-range-po-1-10)# vlt delay-restore orphan-port ignore-vlti-failure
Supported Releases
10.5.2 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\