Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Convert a secondary or promiscuous port to a regular L2 port

You can convert a secondary or promiscuous port to a regular L2 port.

Remove the secondary or promiscuous port from the PVLANs before you convert it to a regular port. If you change the PVLAN port mode while the port is a member of a primary VLAN, the following message appears: 
%Error: interface is a member of private-vlan
A promiscuous port is a member of a primary VLAN. OS10 does not allow you to change the PVLAN port mode when the port is a member of the primary VLAN.
  1. Enter Configuration mode. 
    OS10# configure terminal
  2. Enter Interface Configuration mode. 
    OS10(config)# interface ethernet 1/1/5
  3. Remove the port from the PVLANs. 
    OS10(conf-if-eth1/1/5)# no switchport access vlan
OS10(conf-if-eth1/1/5)# no switchport trunk allowed vlan 10
    OS10(conf-if-eth1/1/5)# show configuration 
! 
interface ethernet1/1/5 
no shutdown 
private-vlan mode promiscuous
switchport mode trunk
  4. Reset PVLAN Port mode. 
    OS10(conf-if-eth1/1/5)# no private-vlan mode
    OS10(conf-if-eth1/1/5)# show configuration 
! 
interface ethernet1/1/5 
no shutdown
switchport mode trunk

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\