Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

trust-map

Configures trust map on an interface or on a system QoS.

Syntax
trust—map {dot1p | dscp} {default | trust-map-name}
Parameters
  • dot1p — Apply dot1p trust map.
  • dscp — Apply dscp trust map.
  • default — Apply default dot1p or dscp trust map.
  • trust-map-name — Enter the name of trust map.
Default
Disabled
Command Mode

INTERFACE

SYSTEM-QoS

Usage Information
Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp] [trust-map-name] command to view the current trust mapping. You must change the trust map only during no traffic flow. Verify the correct policy maps are applied. The no version of this command returns the value to the default. The no version of this command removes the applied trust map from the interface or system QoS.
Example 
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# trust-map dot1p default
OS10(conf-if-eth1/1/10)# trust-map dot1p d1

OS10(config)# interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# trust-map dscp default
OS10(conf-if-eth1/1/2)# trust-map dscp d2
OS10(config)# system qos
OS10(config-sys-qos)# trust-map dot1p default
OS10(config-sys-qos)# trust-map dscp d2
Supported Releases
10.4.1.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\