Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

boot system

Sets the boot image to use for the next reboot.

Syntax
boot system {active | standby}
Parameters
  • active — Reset the running image as the next boot image.
  • standby — Set the standby image as the next boot image.
Default
Active
Command Mode
EXEC
Usage Information
Use this command to configure the location of the OS10 image used to reload the software at boot time. Use the show boot command to view the configured next boot image. This command applies immediately and does not require the commit command.
NOTE: Every time during an upgrade, the startup configuration is copied from a lower version to a higher version whether or not a configuration file is available in the image corresponding to the higher version.
Example 
OS10# boot system standby
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\