Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Assign an interface back to the default VRF instance

Table 1. Configurations to be deletedConfigurations to be deleted
CONFIGURATION MODE COMMAND
IP address—In interface configuration mode, undo the IP address configuration. INTERFACE CONFIGURATION OS10(conf-if-eth1/1/10:1)#no ip address ipv4-address or no ipv6 address ipv6–address
Port—In interface configuration mode, delete the interface association corresponding to the VRF instance that you want to delete. INTERFACE CONFIGURATION OS10(conf-if-eth1/1/10:1)#no ip vrf forwarding

To assign an interface back to the default VRF, perform the following steps:

  1. Enter the interface that you want to assign back to the default VRF instance.
    CONFIGURATION
    interface ethernet 1/1/1
  2. Remove the IPv4 address associated with the interface.
    INTERFACE CONFIGURATION
    no ip address
  3. Remove the IPv6 address associated with the interface.
    INTERFACE CONFIGURATION
    no ipv6 address
  4. Assign the interface back to the default VRF instance.
    INTERFACE CONFIGURATION
    no ip vrf forwarding

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\