Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Assign an interface to a non-default VRF instance

After creating a non-default VRF instance, you can associate an interface to the VRF instance that you created.

To assign an interface to a non-default VRF, perform the following steps:

  1. Enter the interface that you want to assign to a non-default VRF instance.
    CONFIGURATION
    interface ethernet 1/1/1
  2. Remove the interface from L2 switching.
    INTERFACE
    no switchport
  3. Assign the interface to a non-default VRF.
    INTERFACE CONFIGURATION
    ip vrf forwarding vrf-test
    Before assigning an interface to a VRF instance, ensure that no IP address is configured on the interface.
  4. Assign an IPv4 address to the interface.
    INTERFACE CONFIGURATION
    ip address 10.1.1.1/24
  5. Assign an IPv6 address to the interface.
    INTERFACE CONFIGURATION
    ipv6 address 1::1/64
    You can also auto configure an IPv6 address using the ipv6 address autoconfig command.
    NOTE: Before configuring any routing protocol in a VRF instance, you must first assign an IP address to at least one of the interfaces assigned to the VRF instance on which you want to configure routing protocols.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\