Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell SmartFabric OS10 User Guide Release 10.5.3

PDF

Configure PIM join filters

Before you configure a PIM join filter, enable multicast routing globally and establish PIM neighborship between routers. For more information, see the ip multicast-routing command.

To configure a join filter that applies an ACL to the interface:

  1. Configure an ACL in CONFIGURATION mode. You can specify the ACL name up to 140 characters. 
    OS10# configure terminal
OS10(config)# ip access-list pim_joinfilter
OS10(config-ipv4-acl)# permit ip 10.10.10.0/24 226.1.1.0/24
OS10(config-ipv4-acl)# permit ip any 225.1.1.0/24

    PIM join filter uses both source and group information from the access-list for filtering joins. In this example, the first permit ip command is used to filter Join messages for an (S,G) pair. The second permit ip command is used to filter all join messages for a Group (G) irrespective of the sources.

  2. Configure an Ethernet interface. This command enables INTERFACE configuration mode. 
    OS10(config)# interface ethernet 1/1/1
  3. Configure a join filter that applies the previously created ACL (pim_joinfilter) on the PIM interface. 
    OS10(conf-if-eth1/1/1)# ip pim join-filter pim_joinfilter

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\